Dual Gigabit Ethernet Base Board for Raspberry Pi Compute Module 4

Artikelnummer: 11603

Delivery Time: ab Lager

Verfügbarkeit: Sofort-Versand ab Lager

CHF 74.90

Handbücher

Artikelbeschrieb

Details

Dual Gigabit Ethernet Base For CM4

Suitable For Evaluating The Raspberry Pi CM4 Or Being Integrated Into End Products

Powerful Ethernet Capability

CM4 SOCKET	suitable for all variants of Compute Module 4
ETHERNET	Dual Gigabit Ethernet RJ45
USB	USB 3.2 Gen1 × 3
PIN HEADER	40PIN GPIO header × 1
HDMI	HDMI × 2, supports 4K 30fps output
DSI DISPLAY	MIPI DSI display port × 1, 15pin 1.0mm FPC connector
CSI CAMERA	MIPI CSI-2 camera port × 2, 15pin 1.0mm FPC connector
POWER INPUT	7V-36V
FAN	5V/12V, allows speed adjustment and measurement
RTC	Real-time clock with battery socket and ability to wake Compute Module 4
SD CARD SLOT	MicroSD card socket for Compute Module 4 Lite (without eMMC) variants

Standard CM4 Socket And Color-Coded Raspberry Pi 40PIN GPIO Header
Suitable For Compute Module 4 Lite/EMMC Series Module

Providing Interfaces Including: ETH/CSI/DSI/RTC/HDMI/Micro SD/USB

CM4 socket
suitable for all variants of Compute Module 4
40PIN GPIO header
for connecting sorts of HATs
RJ45 Gigabit Ethernet
dual RJ45 Gigabit Ethernet, 10/100/1000M compatible
ETHERNET 0: CM4 original ETH
ETHERNET 1: USB extended ETH
USB 3.2 ports
3x USB 3.2 Gen1, for connecting sorts of USB devices
HDMI connectors
2x HDMI, supports 4K 30fps output
CAM
2x MIPI CSI camera ports
DC power supply
7~36V DC wide voltage range power input
Dual LED indicators
red: Raspberry Pi power indicator
green: Raspberry Pi operating status indicator
Micro SD card slot
for connecting a Micro SD card with pre-burnt image (Lite variant ONLY)
FAN header
for connecting cooling fan, allows speed adjustment and measurement
DISP0
MIPI DSI display port
USB SLAVE port
for burning system image into Compute Module 4 eMMC variants
RTC battery holder
supports CR1220 button cell

RTC interruption configuration
PI-RUN: CM4 will reboot on RTC interruption
GN-EN: CM4 powerdown on RTC interruption
D4: D4 pin is triggered on RTC interruption
IO-VREF selection
set the CM4 IO logic level as 3.3V or 1.8V
FAN power supply selection
select 5V or 12V power to drive the fan
System function configuration
BT_DIS: Bluetooth disabled, for CM4 with antenna variant ONLY
WiFi_DIS: WiFi disabled, for CM4 with antenna variant ONLY
WP_DIS: boot mode switch, ONLY be used when NOT booted from eMMC or SD card
RTC/FAN I2C bus selection
SDA0/SCL0: I2C-10 is shared with CSI/DSI
GPIO3/2: I2C-1 is shared with 40PIN header
RTL8153
USB Gigabit Ethernet chip
EMC2301
fan controller, allows fan speed adjustment and measurement
VL805
USB 3.0 HUB

CM4, display, cameras, and fan are NOT included.

WIKI: CM4-DUAL-ETH-BASE

video title