BME688 Environmental Sensor

BME688 Environmental Sensor, Supports Temperature / Humidity / Barometric Pressure / Gas Detection, optional AI function

Artikelnummer: 12114

Delivery Time: ab Lager

Verfügbarkeit: Sofort-Versand ab Lager

CHF 28.90

Handbücher

Wiki BME68X Environmental Sensor

Artikelbeschrieb

Details

Supports temperature, humidity, barometric pressure and gas detection

Supports Raspberry Pi / Raspberry Pi Pico / Arduino / ESP32 .

Onboard BME688 sensor to measure temperature, humidity, barometric pressure, and gas
Supports I2C communication, I2C address configurable, with I2C bus cascading support
Supports SPI communication, enabled via CS pin (I2C bus by default)
Onboard voltage translator, compatible with 3.3V/5V level
Comes with online development resources and manual (examples for Raspberry Pi / Raspberry Pi Pico / Arduino / ESP32)

MODEL		BME688
DETECTION SUPPORT		Barometric pressure, Environmental temperature, Relative humidity, VOC and VSC gas change detection (supports IAQ calculation in combination with the software package, and integrated AI function)
COMMUNICATION INTERFACES		I2C and SPI
TEMPERATURE SENSING	RANGE	-40~85°C
TEMPERATURE SENSING	ACCURACY	±0.5℃ (0~65℃)
HUMIDITY SENSING	RANGE	0~100%RH
HUMIDITY SENSING	ACCURACY	±3%RH
BAROMETRIC PRESSURE SENSING	RANGE	300~1100 hPa
BAROMETRIC PRESSURE SENSING	ACCURACY	±0.6hPa (0~65℃)
GAS SENSING		supports VOC and VSC gas change detection
DIMENSIONS		27 × 20mm

For Use With Controller Boards Like Raspberry Pi/Raspberry Pi Pico/ESP32/Arduino

PIN	I2C	SPI
CS	NC	SPI chip selection, low active
ADDR/MISO	I2C address chip selection high level (default) address: 0x77 Shorting onboard ADDR pad, the address is 0x76	SPI data master input/slave output
SCL/SCK	I2C clock	SPI clock input
SDA/MOSI	I2C data	SPI data master output/slave input
GND	Ground
VCC	3.3V/5V power supply

Weight: 0.008 kg

Zusatzinformation

Zusatzinformation

Connector	n/a